This was the roll out of the Toytec prototype in Japan back in the 1980's

Toytec minigun paper instructions with multilanguage support.

Parts is parts, this is a wide mix of die cast pot metal, sheetmetal with some steel bearings and brass.

Spring piston air cylinder set that gives the TT its punch without having to lug a CO2 tank around.

 

Note the spline pickup blades, now imagine this running at 50-100rpm in the channel slot of the photo below. Now you may imagine why this had to use harder than standard airsoft pellets. A case of them is also pictured below.

Pellet pickup channel.

A case of special airsoft pellets for the TT design mini.

Back To The Miniguns

Copyright © 2004 Montysminiguns.com
Last Update 02/10/2019 5:35 PM Added Page